Wixey WR550 REMOTE PLANER READOUT Manuel d'utilisateur télécharger pdf (Page 6)

8-Removing an Exact Amount of Material

Follow steps 1-3 below when you want to make a final pass to remove an exact amount of material.

9-Trouble Shooting

Readout issues

The Digital Readout will not function properly or display numbers correctly unless the cable is connected to

both the display and sensor. Do not install the batteries or turn it on until everything is properly connected.

Unstable constantly scrolling numbers

• Insure the sensor is properly installed on the scale.

• Remove the battery, wait 30 seconds and replace it.

Flashing digits, dim, or no display

• Install new batteries.

• Clean batteries and battery contacts.

Frozen display

• Remove the battery, wait 30 seconds and replace it.

IN/MM

ABS/INC

ON/OFF

HOLD TO CAL

-0.035

INC IN

3. ADJUST THE CUTTER HEAD UNTIL THE

DISPLAY SHOWS THE AMOUNT OF

MATERIAL YOU WOULD LIKE REMOVED

IN/MM

ABS/INC

ON/OFF

HOLD TO CAL

0.000

INC IN

1. AFTER RUNNING A BOARD THROUGH THE

CUTTER HEAD DO NOT ADJUST THE HEIGHT

2. PRESS TO PUT INTO THE INC MODE AND SET

THE DISPLAY TO 0.000

1 2 3 4 5 6 7 8

Pas de commentaire

Wixey WR550 REMOTE PLANER READOUT Manuel d'utilisateur Page 6